Dongfeng Xinjiang X7 truck parts left front fog light 3732110-C33X701SY

Equipped with a 30W high-performance LED light source (12pcs 2.5W SMD LEDs), the fog light delivers a luminous flux of 3,200 lumens—3x brighter than traditional halogen fog lights (1,000 lumens)—and a 6,000K cool white light that penetrates fog, rain, and snow more effectively. The light beam features a wide-angle, low-beam design (120° horizontal coverage, 45° vertical coverage) that illuminates the road surface 15–20 meters ahead without dazzling oncoming vehicles, fully complying with ECE R19 fog light safety standards. In Xinjiang’s frequent heavy fog (visibility ≤200m) or sandstorm conditions, a special optical lens reduces light scattering by 40%, enhancing beam penetration to help drivers clearly identify road edges, potholes, and obstacles. The LED lifespan exceeds 50,000 hours—10x longer than halogens—eliminating frequent replacements for X7 trucks operating in remote mining or long-haul routes

Engineered to withstand Xinjiang’s extreme environmental conditions (sandstorms, heavy snow, -35°C to 45°C temperature swings), the fog light achieves an IP68 protection rating—the highest level for automotive lighting. The housing is made of die-cast aluminum alloy (ADC12 grade) with a tensile strength of 220 MPa, resisting impact from flying stones (tested to 50J impact force without cracking). The lens uses 4mm-thick tempered glass with an anti-scratch coating (Mohs hardness ≥6H), preventing abrasion from sand particles common in Xinjiang’s desert regions. The wire entry is sealed with a silicone gasket and heat-shrinkable tube, blocking dust and water intrusion even during 30 minutes of 1m-deep water immersion. Additionally, the housing’s surface is coated with a UV-resistant ceramic layer, passing 3,000 hours of xenon lamp aging with no discoloration or material degradation—critical for enduring Xinjiang’s 3,000+ annual hours of intense sunlight

To ensure reliability in the X7’s complex electrical system, the fog light integrates a comprehensive protection circuit. A built-in temperature sensor triggers current limiting when the housing temperature exceeds 85°C (common in desert heat), reducing power consumption by 20% to prevent LED burnout. An overvoltage protector cuts off power if voltage exceeds 16V (e.g., due to alternator faults), safeguarding the LED driver from damage. Reverse polarity protection also prevents short circuits if the wiring is connected incorrectly during installation. These features meet ISO 16750 automotive electrical standards, ensuring stable operation even when the X7’s air conditioning, radar, and other high-power accessories are used simultaneously—critical for long-haul drivers relying on consistent lighting

Designed for easy replacement by fleet technicians or remote repair teams, the fog light simplifies installation with user-friendly features. The wiring harness includes a plug-and-play connector that matches the X7’s factory fog light socket—no cutting, soldering, or adapter required—reducing wiring time by 80%. The mounting kit comes with 4 stainless steel M6×16mm screws (rust-resistant for snowy winters) and lock washers, which can be tightened with a standard Phillips screwdriver in 15–20 minutes. The housing has a built-in alignment mark that lines up with the bumper’s reference line, ensuring accurate beam angle without post-installation adjustment. Each unit undergoes 100% light output testing, waterproof verification, and electrical performance checks, backed by a 24-month warranty against defects (e.g., LED failure, housing cracking, water leakage)