Dongfeng KInland truck parts Left front fog lamp assembly 3732020-C0100

Equipped with a 28W high-performance amber LED light source (14pcs 2W SMD LEDs), the fog lamp delivers a luminous flux of 3,000 lumens and a 3,000K warm amber color temperature—optimized for cutting through fog, rain, and snow. Amber light scatters 30% less than white light in misty conditions, extending the driver’s visible range to 25–30 meters ahead (vs. 15 meters for white fog lamps). The light beam features a wide-angle, low-beam design (130° horizontal coverage, 50° vertical coverage) that illuminates road edges and potholes without dazzling oncoming vehicles, fully complying with ECE R19 and GB 4785 fog light safety standards. The LED lifespan exceeds 50,000 hours—10 times longer than traditional halogen fog lamps—eliminating frequent replacements for Kinland trucks operating in fog-prone regions (e.g., coastal areas, mountainous highways)

Engineered to withstand the harsh conditions of truck operation—heavy rain, snow, road salt (winter de-icing), and dust—the fog lamp achieves an IP68 protection rating (the highest for automotive lighting). The housing is made of die-cast aluminum alloy (ADC12 grade) with a tensile strength of 210 MPa, resisting impact from flying stones (tested to 45J impact force without cracking). The lens uses 4mm-thick tempered glass with an anti-scratch coating (Mohs hardness ≥6H), preventing abrasion from sand or road debris. The wire entry is sealed with a silicone gasket and heat-shrinkable tube, blocking water and dust intrusion even during 30 minutes of 1.5m-deep water immersion. Additionally, the housing’s surface is treated with a ceramic coating that resists UV degradation (passing 3,000 hours of xenon lamp aging with no discoloration), ensuring stable performance in intense sunlight

To safeguard the Kinland’s electrical system and the fog lamp itself from damage, the assembly integrates a multi-layer protection circuit. A built-in temperature sensor triggers current limiting when the housing temperature exceeds 80°C (common in high-temperature environments or prolonged use), reducing power consumption by 20% to prevent LED burnout. An overvoltage protector cuts off power if the system voltage exceeds 16V (e.g., due to alternator faults), safeguarding the LED driver from damage. Reverse polarity protection also prevents short circuits if the wiring is connected incorrectly during installation—avoiding damage to the truck’s fuse box or wiring harness. These safety features meet ISO 16750 automotive electrical standards, ensuring reliable operation even when the Kinland’s air conditioning, radar, and other high-power accessories are used simultaneously

Designed for easy replacement by fleet technicians or remote repair teams, the fog lamp simplifies installation with user-friendly features. The wiring harness includes a plug-and-play connector that matches the Kinland’s factory fog light socket—no cutting, soldering, or adapters required—reducing wiring time by 80%. The mounting kit comes with 4 stainless steel M6×14mm screws (rust-resistant for snowy winters) and lock washers, which can be tightened with a standard Phillips screwdriver in 15–20 minutes. The fog lamp’s housing has a built-in alignment mark that lines up with the bumper’s reference line, ensuring accurate beam angle (no need for post-installation adjustment). Each unit undergoes 100% light output testing, waterproof verification, and electrical performance checks, backed by a 24-month warranty against defects (e.g., LED failure, housing cracking, water leakage)